- Página principal /
- Productos /
- Micrófonos /
- Micrófonos de estudio /
- Micrófonos de condensador de estudio /
- Micrófonos de condensador de membrana grande /
- SE Electronics /
- SE Electronics SE4400A-ST estéreo para micrófono condensador
SE Electronics SE4400A-ST estéreo para micrófono condensador
General
This set consists of two sE Electronics 4400A condenser microphones, which together, let you create recordings in a mono stereo signal. The SE4400A is mainly the same as the SE2200A, but it has a double diaphragm, instead of the one.
You can especially notice this in the improved cardioid pickup pattern. Talking of pickup patterns, you can switch between four different ones - cardioid, super-cardioid, omnidirectional or figure-8. This way, you can always use this microphone to ideally record or amplify your sound source, adjusting the pickup pattern to the use.
The sE Electronics 4400A has a flat design, so that it can be placed very close to (bass) guitar amps and drumheads. It can also be used for vocal recordings and live gigs in pubs. Furthermore, a shockmount is included that fits on any microphone stand.
The microphone is suspended just out of the shockmount, so that the SE4400A is ideal for close-miking. With this microphone you can select the pickup pattern that matches your application - you will be hard put to find a use for which it isn't useful!
Sugerencias o comentarios sobre este producto
-
SE Electronics have composed a practical table that lets you see which microphone is the best for your application.
Características
Características del producto
- Válvulas de micrófono no
- Sensibilidad micrófono (dBV/PA) -37
- Impedancia micrófono 50-99 Ohm
- Filtro cutº sí
- SPL máxima 130 dB - 139 dB
- Frecuencia máxima 20 - 20.9 kHz
- Accesorios de micrófono montura antivibratoria, barra estéreo
- Frecuencia mínima 20 - 21 Hz
- Pad conmutable sí
- Patrón de captura cardioide, bidireccional, omnidireccional, multipatrón
- Estéreo sí,
Peso y las dimensiones incluyen el paquete
- Peso (incluyendo el paquete) 4,1 kg
- Dimensiones (incluyendo el paquete) 36,0 x 27,5 x 15,0 cm
Características del producto
- frequency range: 20 Hz to 20 kHz
- sensitivity: 14.1 mV/Pa -34 ± 1dB
- selectable cardioid pickup pattern, cardioid, figure-8, omnidirectional, super-cardioid
- impedance ≤ 50 ohms
- signal/noise ratio: 17 dB
- maximum SPL 0.5 % THD at 1,000 Hz: 130 dB
- required power supply: phantom power 48V ±4V