- Página principal /
- Productos /
- Audio profesional /
- Amplificadores /
- DAP /
- DAP CX-2100 amplificador 990W PA (2 unidades)
DAP CX-2100 amplificador 990W PA (2 unidades)
General
This DAP Audio CX-2100 is an impressive amplifier - thanks to its quality and power handling! The CX-2100 has a maximum power of 2x 990 watts and is therefore fit for travelling DJs and musicians, as well as for fixed locations like discotheques, community centres and pubs. A unique quality of this amplifier is that it's provided with a reset button at the rear and that you can daisy chain to other amplifiers via XLR cables.
The CX-2100 amplifier
This amplifier is one of the five models of the CX series. These five are quite alike, but all have different power handling. The CX-2100 is the second most powerful unit from the series, so if you want to go to town properly, this amplifier is what you need! Via daisy chaining, you can amplify a separate subwoofer next to full-range speakers. If you want to use multiple amplifiers simultaneously, it might be practical to build these into a rack. As the CX-2100 is a 19-inch amplifier, it can also be built into a rack. The CX-2100 is 2 U high.
Safety first!
As this amplifier produces a lot of power, it needs to be properly protected. It is protected against short-circuiting, overheating, overloading and DC overvoltage, and is equipped with soft start and a (fixed) clip limiter. With the reset button at the rear you can stop the operations of this unit via one press. Besides the interior protections, this PA amplifier also has a highly durable exterior. The CX-2100 is a very safe, durable amplifier with impressive power handling and an attractive price.
Características
Características del producto
- Formato rack 19 sí, 2 U
- Compatibilidad 2 Ohm no
- Number of amplifier channels 2
- Salida bucle de audio sí
- Modo puente sí
- Conector de entrada XLR
- Filtro ninguno
- Protecciones sobrecarga, térmica, cortocircuito, voltaje DC, indicador clip
- Procesador DSP no
- Refrigeración ventilador
- RMS power (4 ohms) per channel 900 - 999 watts
- RMS power (at 8 Ohms) per channel 700 - 799 Watts
- Tipo de ampli sin especificar
- Salida de ampli speakerconnector
- Provisto de crossover no
Peso y las dimensiones incluyen el paquete
- Peso (incluyendo el paquete) 14,5 kg
- Dimensiones (incluyendo el paquete) 48,2 x 25,6 x 8,8 cm
Características del producto
- DAP Audio CX-2100 19-inch PA amplifier
- frequency response: 20 Hz - 20 kHz, + 0.1 dB
- THD: less than 0.5%
- air stream: front to back
- damping factor at 8 ohms < 200
- crosstalk @ 1 kHz: -75 dB
- crosstalk @ 20 kHz: -58 dB
- signal-to-noise ratio > 100 dB, A-weighted
- input sensitivity: 0.775 V / 1.4 V
- input impedance: 20 kOhms balanced, 10 kOhms unbalanced
- output modes: stereo, parallel and bridged
- fan speed adjusts in adjusts in accordance with power amplifier
- power supply: 230 V / 50 Hz
output power stereo:
- 8 ohms: 2x 700 watts RMS
- 4 ohms: 2x 990 watts RMS
- 2 ohms: not allowed
output power bridged:
- 8 ohms: 2000 watts RMS
- 4 ohms: not allowed
Opiniones
Reseñas de otros países
Traducir todos los comentarios al español
Uitstekende versterker, prijs kwaliteit verhouding is zeer goed.
Zowel xlr male and female klikken in plaats en zitten degelijk op ze plek.
Het geluid van de fans is minimaal. Grote ring-kern trafo binnen in.
Ziet er allemaal goed uit, degelijk gebouwd en heel wat vermogen.
Zeer tevreden met de versterker.
Uitstekend geluid.
zeer nette versterker, weinig poes-pas zoals het het lekkerste werkt
prijs kwaliteits verhouding is perfect. net mooi voor op mijn kamer op de 2x peavey sp215.
maar ondanks het meer vermogen dat de versterker kan leveren vind ik hem voor livegebruik minder aantrekkelijk